Section 422.135. Molded wood parts or products.

 

(1)   Applicability.

(am) Except as provided in par. (b) , this section applies to molded wood parts or products coating lines of any molded wood parts or products coating facility that is either of the following:

1. Located in the county of Kenosha, Milwaukee, Ozaukee, Racine, Washington, or Waukesha and which has maximum theoretical emissions of VOC from all wood entry or passage door coating at the facility greater than or equal to 25 tons per year.

2. Located in the county of Kewaunee, Manitowoc, or Sheboygan and which has maximum theoretical emissions of VOC from all wood entry or passage door coating at the facility greater than or equal to 100 tons per year.

(b) This section does not apply to the use of topcoats which are applied as a stripe not more than 1/2 inch in width to croquet balls and whose use in aggregate never exceeds 500 gallons in a year, as applied.

(2)   Emission limitations.

(a) No owner or operator of a molded wood parts or products coating facility which uses flow coating to apply topcoats may cause, allow or permit the emission of any VOCs in excess of the limitations specified in Table 3.

(b) No owner or operator of a molded wood parts or products coating facility which applies a topcoat using any application method other than flow coating may cause, allow or permit the emission of any VOCs in excess of the limitations specified in Table 4. - See PDF for table - See PDF for table

(3)   Recordkeeping requirements. Any facility subject to this section shall comply with the requirements applicable under s. NR 439.04 (5) .

Cr. Register, August, 1994, No. 464 , eff. 9-1-94; CR 00-174 : am. (2) (a) and (b), renum. Tables 2 and 3 to be Tables 3 and 4, Register August 2001 No. 548 , eff. 9-1-01; CR 11-005 : renum. (1) (intro.) to be (1) (am) (intro.) and am., r. (1) (a), cr. (1) (am) 1., 2., am. (1) (b) Register January 2012 No. 673 , eff. 2-1-12.